This base casting needed to be filed so as to remove the rounded area, and to flatten the bottom of the threaded area. An AR 15 with front sight can be more complicated though. Am I missing something here or do I have the easiest way to do it in mind? I was pounding the front sight to all hell, but the pins will not budge, even when soaked in WD40. How to Mount a Scope On AR-15 With Front Sight (2022. The front sight is also used to protect the gas block from damage. First, the threaded hole that accepts the "post" is drilled through, threaded, and a set screw is installed from below. However, it is important to note that this is not an easy task and will require some modification to the gun.
Adds accessory mount rails on left, right and bottom (Picatinny) - Includes space for the sling adapter hoop. Simply unscrew the factory sight post and screw in the Blitzkrieg Components sight post using either our sight tool or a standard A2 sight tool. 5 Copyright © 2023 vBulletin Solutions Inc. All rights reserved. The bold, contrasting Luminescent Green Stripe gives the shooter an eye catching sight picture that excels in both bright-light and low-light environments and against all types of backgrounds. Good quality machine work and small enough to stick in your pocket. Lip of spacers should face forwards (see main photo). A hex headed set screw mounting system on the sightbase may be less of a headache to install. If don't have flip-up irons, or the common combo of one flip-up and the other on your ar 15 not, then I would recommend a ⅓ co-witness. Ar 15 front sight post removal. We carry a number of styles from several manufacturers, including AR 15 fixed iron sights and AR 15 flip-up iron sights. This tool consists of a clamp that fits over the front sight and provides a guide that keeps the punch from wandering. Remove The Sights, If Desired. Use the punch to drive the pin back into place.
Once the pin is removed, the front sight can be slid off the gas block. Cookies are not currently enabled in your browser, and due to this the functionality of our site will be severely restricted. The front sight assembly won't just jump off after you get the pins out.
Hunters, Fisherman and other liars gather here. Now take a 3x36 set-screw and insert it in the top of the base as if it were the post. When you pull the A2 front sight off, knock out the very small pin that holds the gas tube in place and reinstall in your new gas block. The front sight can be removed from the gas block, but it is not recommended. Currently I have a rear flip up sight (MagPul) and the stock A2 front sight post. I didn't need to re-tap it, after filing, the set-screw passed through easily. Look closely at this picture and compare it with the one below, note the area pointed to by the pencil in the lower photo. AR-15 .223/5.56 Front Sight Post Tri Rail Barrel Mount w/ Spacers | for AR accessories, handguards, .223 .556 .308. I tried using roll pin punches but the pins didn't even budge. To provide a fast, secure, and enjoyable experience. All this is available for a reasonable price. Ended up taking a dremel to the front sight and chopped it off. This position will allow you to put the scope on the firearm in a secured manner. The scope rings should be on the same gap level that allows the user to move the optic. You tube will make it easy to understand and its not a hard job if you are comfortable doing it.
The gas block and flash hider have to come off to get the barrel off anyway so more steps for a gunsmith equals more money out of your pocket. 11-07-2020, 08:03 PM. We also offer our own Del-Ton backup iron sights, made in the United States under our strict standards. These are the pieces required.