During normal mowing operations on an established lawn, the deck belt on your Craftsman FS5500 riding mower usually lasts for two or three mowing seasons. Craftsman t110 riding mower belt diagram. Wiggle the belt between the pulley and the guide to remove it. Secure the anti-sway bar by replacing the washer and retainer spring removed earlier onto the end of the anti-sway bar protruding through the right suspension bracket. Remove all dirt and grass clippings from around the pulleys and the upper deck surface with a stiff-bristle brush.
Repeat and attach the left rear lift link the same way. Move to the right of the mower. Belt diagram for craftsman riding mower. Disconnect the front link between the deck and the mower chassis by removing the retainer spring and washer from the pin on the chassis and pulling the front of the link from the pin. Go to the left side and push the belt tension rod down and then secure it by hooking it into the slot in the lock bracket. Reach under the right rear of the mower deck. The second mandrel pulley is located directly across from the first mandrel pulley, on top of the mower deck. Slide the loose front section of the new belt over the electric clutch pulley.
Williams is a winner of Writer's Digest Magazine's annual writing competition. Put the screws inside the covers and lay them aside. If necessary, refer to the photo you took after removing the mower deck from the lawn tractor. Attach the right rear lift link by lifting the corner of the deck and positioning the slot in the end of the link over the pin protruding from the rear lift arm bracket. Install the belt around the three mandrel pulleys with the "V" of the belt facing inward toward the pulley groves. Lift the anti-sway bar and insert the far end into the hole in the left transmission bracket. Remove the retainer spring and washer by hand from the pin protruding through the hole in the front right suspension arm located on the upper front of the deck, and then disengage the link. Secure it with the washer and retainer spring removed earlier. Craftsman riding mower drive belt diagram. Loop the flat side of the belt over the two idler pulleys and feed the loose end of the belt forward towards the clutch pulley position. But when mowing through unfinished areas, friction caused by flying dust, gravel and debris causes abnormal belt wear. Point the mower deck suspension arms towards the front. Once free, ease the end slowly upward to release tension on the mower deck belt. Avoid this problem by taking a picture of the old belt while it's still on the mower deck (after the mower deck has been removed from the lawn tractor).
Install the new belt onto the mandrel pulley with the large belt guide by slipping it between the pulley and the guide. When working on your lawn mower, always engage the brake to prevent rollaway, turn off the engine and remove the key to prevent injury. Remove the retainer spring and washer from the anti-sway bar connected to the right rear lift arm bracket. Ensure the belt is completely in the pulley grooves. Lift the deck by raising the attachment lift lever to highest position to complete the installation. Go to the other side of the tractor and reinstall the left front suspension arm the same way. Remove the screws securing both mandrel covers to the left and right of the deck using a Phillips screwdriver. If you forgot to take a picture of your mower's deck belt before removing it, refer to your mower's owner manual for the correct routing pattern. Wind the belt onto the mandrel pulley near the grass discharge. Slip the belt off the pulley by hand.
Then you only need your two hands to remove the old belt and install the new one. Reach underneath and remove the belt from the electric clutch pulley situated in front of the deck. Slide the mower deck out from under the right side of the tractor. Reinstall the two outer mandrel covers and tighten the screws securely. This pulley may have a small belt guide that looks like a narrow piece of metal sticking up beside the pulley. Replacing the deck belt on your Craftsman lawn mower is a relatively easy operation once the mower deck is removed from the lawn tractor. Slide the deck under the tractor and center it front to back and side to side.