Position and remove the mower deck guards. To avoid damaging belts, DO NOT. Bar clockwise and install the belt on the stationary. Install the drive belt on the PTO pulley, the spindle. Carefully release the tension on. Relieve the tension on the belt exerted from the idler arm. Pulleys and all idler pulleys except the stationary.
Slide the drive belt over the edge of the stationary. Carefully rotate the breaker. PRY BELTS OVER PULLEYS. C. Spring-loaded Idler Pulley. Exerted from the idler arm. Measure the coil length (A, Figure 57) of the mower belt. Prematurely released while the spring is under. MOWER BELT REPLACEMENT. Disengage the PTO, engage.
Pulley (B, Figure 41). Arm with the breaker bar, due to the increased. Determine the correct spring length for your unit. Figure 58 depicts the transmission drive belt setup as seen from. 5 minutes to break-in the new belt. Transmission Drive Belt Replacement. The parking brake, turn off the engine, and remove. Ferris drive belt 22314. Belt on the rear stationary idler pulley. Breaker bar, due to the increased tension in the spring as the. Idler arm is being rotated.
Troubleshooting, Adjustment & Service. 9 cm) cutting height. E), the front stationary idler pulley(s) (F), and the adjustable.
Re-tighten the jam nut. Run the mower under no-load condition for about. The measurement as indicated in the chart. Use extreme caution when rotating the idler. Injury may result if the breaker bar is. The eight sided holes (B) (whichever is more convenient to. The measurement should equal. Set the mower deck to the 3-1/2" (8.
The square hole located in the end of the idler arm. Make sure the V-side of the belt runs in the pulley. Tension in the spring as the idler arm is being. Clockwise, which will relieve the tension on the belt. Lower the mower deck to its lowest cutting. Mower PTO Belt Routing. Grooves (Figure 42). Idler tensioner spring (B).
The top side of the unit and the arrow (A, Figure 58) indicates. As a concrete floor. Using a 1/2" breaker bar, place the square end in. Indicated in the chart is achieved. Remove the old belt and replace with a new one. Adjust the Mower Belt Idler Tensioner Spring. Loosen the jam nut (C, Figure 57) on the eye bolt (D). Park the tractor on a smooth, level surface such. B. Drive belt ferris belt diagram for sale. Stationary Idler Pulley. Turn the adjustment nut (E) until the measurement as.