These auto are known for fuel pump problems. There's a lot of guys on you tube who show how they do it. Fuel pump access cover for truck bed. 275/65/17 Falken Wildpeak AT3W | Shorty Antenna | Tinted Windows | ProClip Phone Mount |5. 0 Sohc, 4x4, Manual trans (hurst equipped), 4:10's, 3" body lift. Drop the module back in, lock the ring in place, attach the connectors. After looking online, you either have to drop the fuel tank or remove the entire truck bed. I had to pay to have mine done (and I HATE paying) a few years back.
When I removed the carpet from the back I came across this. If anyone is interested..... 2001 Ford Ranger Supercab (4dr), Oxford White, 4. 5, 5 speed, 2WD, no AC, 150k (SOLD). I have a fiberglass cap that stays on the truck and I have a tool box that is in the bed of the truck all the time except when on vacation.
The fuel pump in order to repair it. I'm planning to hook up some slick aftermarket gauges and modify the sender in Felro86/Midnight Rider fashion. It is easier to take the bed off of the truck than it is to lower the tank. It will rust where you cut. For those wanting to do this, here are the dimensions on a 2016 6 1/2' bed truck= From the front of the box 4 1/8" to front cut and 17 5/8 to back cut. Truck: 2007 F150 Lariat 4x4. Need to change my pump in my 03 Astro cargo van. Where do I Cut In My Truck Bed to Reach the Fuel Pump? | Jerry. The fuel pump itself is inside the fuel tank but you can get to it and remove it from the top of the tank. O well I'll make my own. Join Date: Oct 2009. If you get Delphi or ac delco, the butt connectors with built in heat shrink are ok to use. 0 Econoline platform 6.
Communicate privately with other Tundra owners from around the world. It's free and only takes a minute. Posts: 12, 688. yes just take the damn bed off. 6 duramax G series vans and Topkick chassis. 5 Speed M5R1-RWD--3. I just had a friend go to the dealer to get his pump replaced... Where to cut hole in truck bed for fuel pulp fiction. $600 total ($400 for the pump, $200 in labor), I did mine for $54. I do that from underneath the truck? It was easy to do by myself and way way easier than wrestling a tank around. Location: Wichita Falls, Tx. Location: Binghamton, NY. Cranked but no start, showing code p023f.
Yeah well, I don't have one of those". Anyone done this or have advice? It sounds difficult, but it's just a matter of removing 6-10 bolts and sliding the bed off. Shame on me, I should know better! Too long; didn't read.
The bed is only held on by a few bolts. Even if you can see what's going on down there the hole would have to damn big to work on or make a repair. Last edited by Miyoda; 09-30-2011 at 06:43 PM. Not as smart as I think. The store was an O'Reilleys. Tinted Windows | 6000K HIDs | Kobalt Low Profile Toolbox | Pioneer Speakers. Never heard similar on my '03... Realistically, will the Delco part outlast a very well known name brand like Bosch, and is there actually a difference between the Delphi and AC Delco part for a 97/98 5. One, the fuel level sensor is a wear item and should be replaced when ever the pump needs changed. Anyone cut a fuel pump access panel in their hilux. I do have a drop in liner so it's covered up and you cant see the hole when the liner is in place. Last is the evap hose.